HI:)
Attached the newest spps
BCR2000 as Master, Launch Control as Slave
For the Launch Control I have attached and midiassigned:
Device, Mute, Solo and Record Arm are for switching between the presets on all 4 presets. In CbB Settings/MIdi/Playback and Record/Sysx forwarding must be enabled to LaunchControl XL!
It's not possible to switch Preset + and -, so you can only switch to preset 2 f.e with a sysx Command. Perhaps Alexey can find a better way to do this.
Send Select und Track Select are 4 additional Buttons.
Preset 1: ACT Rotors 1-24, ACT Switches 1-20, ACT Sliders 1-8
Preset 2: ACT Rotors 25-48, ACT Switches 21-40, ACT Sliders 9-16
Preset 3: ACT Rotors 49-72, ACT Switches 41-60, ACT Sliders 17-24
Preset 4: ACT Rotors 73-96, ACT Switches 61-80, ACT Sliders 25-32
BCR2000:
1.Row ACT Sliders 33-40 and with Shiftlock ACT Sliders 41-49
2.Row ACT Rotors 97-104 and with Sjhiftlock ACT Rotors 121-128
3.Row ACT Rotors 105-112 and with Shiftlock ACT Rotors 129-136
4.Row ACT Rotors 113-120
1.Row Buttons 81-88 and with Shiftlock 97-104
2.Row Buttons 89-96 and with Shiftlock 105-112
This should be enough!
For Alexey:
To 1. I changed all these in my Preset
To 2. I did'nt understand first, but now I think Ch:1 CC1 is reserved for the system controls? I have reattached it, it was deleted, maybe it was me...., but now the WAI Display is working again, thanks;)
To 3. Can't find any duplicated. I have a lot of Detached ones now, some of them I can deletes some not, all is greyed out, does this matter?
To 4. Open the first Synth would be very fine, at the moment ACT doesn't work if there's no Plugin in the selected track, so sometimes I have to switch to a track or bus which contain plugins, then I have to click with the mouse in a Synth, then I can switch between the synths...
Thank you very much:)
Heinz.