Author Topic: AZ Controller 0.5r3  (Read 8575 times)

Online azslow3

  • Administrator
  • Hero Member
  • *****
  • Posts: 1790
AZ Controller 0.5r3
« on: November 03, 2016, 11:18:10 AM »
Please visit the documentation section in case you have never installed this plug-in before.

Download it now

There should be no Ads, spies or other nasty parts in this download. The installer does not try to connect to the Internet. If you see such a warning from your OS, stop the installation/use immediately. The DLL can theoretically write a log file into its own folder, but that should not happened with releases. If you turn on OSC in the AZ Controller preferences or load a preset with OSC turned on, AZ Controller is acting as a network server. You can get related warning from your firewall software. Even in this mode AZ Controller does not try to communicate with the Internet, while it will start respond to OSC Clients messages


This is the only place where you can get the original AZ Controller for sure. The license allows coping/distributing it unchanged, but I am not responsible for distributors misbehavior. 

Changelog (b350 - b351)
  • FIX: Touch was not working in case Value action in target control was inside called control

Changelog (b349 - b350)
  • FIX: workaround for bug in Sonar to avoid crash when accessing the first parameter name ("Type") of ProChannel compressor. The problem become more critical in b344 after more accurate parameter changes detection (parameter names are internally recalled even in Value monitors).

Changelog (b344 - b349)
  • FIX: CRITICAL: Memory corruption (Sonar crash) when Send output value is monitored
  • FIX: unseting OSC static client was triggering configuration corruption
  • FIX: an attempt to workaround Sonar Send Output selection bug. Selecting side chains from surface is impossible, operating them is failing instead or side effects

Changelog (b343 - b344)
  • CHANGE: "Note" Set can be "Any" in Action Conditions (only "On" or "Off" was allowed before)
  • FIX: One State name was fixed, not influence on operation

Changelog (since 0.5r2)
  • FIX: Faderport build-in preset initialize the device
  • NEW: Fixed OSC client
  • FIX: ACT Learning was not correctly working from device
  • NEW: State based monitoring (Software Set determines monitor type)
  • NEW: Function to detected either monitored parameter was changed (or just its value)
  • NEW: Automatable mute for strips
« Last Edit: January 07, 2017, 12:11:56 AM by azslow3 »