Hello Alexey
I can see two instances when a full refresh of controller status is outputted by Cakewalk via AZ Controller (I mean the position of faders, source selection etc).
1. When a Cakewalk project is loaded.
2. When an AZ preset is loaded.
Can you tell me if there is any way to invoke a full refresh of Cakewalk controller status by an incoming MIDI command?
To explain the context for my question:
I have two operational modes for my Digitally Controlled Analogue Audio Mixer.
1. REPLAY Mode (so 24 tracks replaying from tape machine through the audio mixer).
2. RECORD Mode (means I use the audio mixer as a recording routing matrix).
So when I change from RECORD to REPLAY mode, I need to reset most audio mixer parameters, and so a full output of the Cakewalk controller status on the feedback MIDI channels, would be really helpful.
Regards
Robert
Hello Robert,
In case preset is constructed the way I personally always do, so whole feedback comes from Monitors, Reset All monitors action does the trick.
Hello Alexey
Thanks for the advice. I tried the 'Reset All monitors' and it worked just fine.
I've attached a photo of my digitally controlled analogue mixer rack frame which I am finally! beginning to populate with cards.
I decided to use two PIC microcontrollers, one for each operating mode: RECORD and REPLAY. So I will use two instances of AZ Controller, each connected to one PIC via MIDI.
Best wishes
Robert
Looks "scientific" ;)