AZSlow
AZ Controller plug-in for Cakewalk SONAR => Discussions => Topic started by: Mathimid on November 20, 2018, 03:40:16 AM
-
Hello there,
First of all, thanks for that nice piece of software. It's might be the rescue solution for my VS-700 system, because the integration of the regular ACT surface in Cakelab becomes more and more buggy. (the last disaster was, that the channel strip control is messed up) So i'm working on an adaptation the the VS-700....Or shall i say tinkering. I've made some good steps forward. The VU meters are working, the access panel is working mostly as desired (excepting the freeze button - i have to use a modifier key to unfreeze track), and so on. The hardest part probably will be the Channel Strip Control area, which i save until i'm done with the rest.
Currently i'm stucking with the control LEDs of the all tracks mute/solo/arm buttons. Usually they should light up if some track is muted/soloed/armed, even if it not in focus of the 8 strips. So, is there a way to check, if there is any track with such a state and then route it over to the correct feedback command?
Best regards
-
Wow. Re-making original VS-700 functionality is not an easy task. ;)
For the question: corresponding parameters are "Rude...".
F.e. for all tracks mute, configure "Strip" action as "Track" "<First>" "Rude mute". Then you can "Monitor parameter value" and "Value toggle" as for a single strip.
-
OK. That was easy. Thanks!
I surely will come up with other issues during my travel through this tangled mass of parameters. ;)
-
You are welcome.