AZSlow

AZ Controller plug-in for Cakewalk SONAR => Wishes => Topic started by: Hermu on May 18, 2015, 01:24:10 PM

Title: AZ Display: Logical On/Off for 'Rude mute/solo' monitoring [there is a solution]
Post by: Hermu on May 18, 2015, 01:24:10 PM

monitoring values for 'Rude mute' and 'Rude solo' shows 0.0 or 1.0 instead On/Off similar 'Mute' or 'Solo'

Title: Re: AZ Display: Logical On/Off for 'Rude mute' and 'Rude solo' monitoring
Post by: azslow3 on May 18, 2015, 03:07:36 PM

Not sure I understand for what it is good, but implemented (in the test version for now).

Title: Re: AZ Display: Logical On/Off for 'Rude mute' and 'Rude solo' monitoring
Post by: Hermu on May 18, 2015, 04:03:58 PM

I have attached AZ Display monitor for Mute and Rude mute, but i meant On/Off should be language specific.

it shows state of muted channels. if one or more channels are muted, also 'Rude mute' is on. with 'Rude mute' button it's possible to switch all muted channels off, or to switch all channels to mute.

Title: Re: AZ Display: Logical On/Off for 'Rude mute' and 'Rude solo' monitoring
Post by: azslow3 on May 18, 2015, 06:16:09 PM

Ok, you get it language specific now.

I know what they are, but "Yes/No", "Ein/Aus" or "Да/Нет", that is normally not the best representation way for these parameters. Even when I want them on Display, I prefer "Rude solo" if it is there and "" (Nothing!) if not.

You can put "Solo nicht vergessen!" or something else, but clearly visible. That is why I was never using direct text representation...

Title: Re: AZ Display: Logical On/Off for 'Rude mute' and 'Rude solo' monitoring
Post by: Hermu on May 18, 2015, 08:25:25 PM

Thanks for your fast support, that's the best solution  :)