AZSlow

I tried clicking on everything possible in the table with files to download, but unfortunately it didn't help. I also tried to expand the "software" link on the product page, but also without success. Axes hammer and looking at the source of the page didn't help me either.

It looks like it's working. I tested a few things and it's basically ok, except that the send gain is adjusted in steps of 0.25db instead of 0.1db, which makes changing by 1 step difficult because the mixer updates the value very quickly to the closest possible one. Another thing is that after sending the /info command, it showed version v0.04, so it is probably very old, if it is the same as the firmware version. In theory, you can download firmware 1.22 on the website, but I was unable to do so. There is a blank line instead of the "download" link. Moreover, it would be useful to be able to check the version without entering the /info command manually.

So it looks like I'll be confirming it. ☺️Unfortunately, I haven't had access to any digital mixer so far, so I may have a few questions, although I tried to review a lot of materials, including the original user manual. Do you have a checklist of things I could check to make sure everything is working properly?

Hi. Do you already know if Air Access 18 works well with Midas mr18? At the moment it is only slightly more expensive than the Behringer xr18, but the difference is that it has a 10-year limited warranty as opposed to the Behringer which has a 3-year limited warranty.

thx. i made a new version to correct a few things.
Do you see any way to command to located the playhead at the end of the pasted clip (so we could instance the copies with the knob)?