Author Topic: Suddenly have to double-press the buttons?  (Read 1794 times)

Offline cupax

  • Newbie
  • *
  • Posts: 23
Suddenly have to double-press the buttons?
« on: April 21, 2021, 10:47:02 PM »
Hello.

My AZslow X Touch One preset works very well.... until it doesn't.

Opening the project everything works as supposed but suddenly (after some minutes of work) I have to press any button on the controller TWICE for theAZslow to work. So I want to stop the playback? I have to press it twice.

Each time I open the AZslow window (Controller/Surface Properties) I noticed that my preset gets an * next to its name, which means it has been modified (not by me).
As soon as I select that same preset again, the * dissappears and the surface works normally (1 press). Until after some minutes of work switches back to double press...

Any ideas?

Offline azslow3

  • Administrator
  • Hero Member
  • *****
  • Posts: 1679
Re: Suddenly have to double-press the buttons?
« Reply #1 on: April 22, 2021, 09:26:16 AM »
Please make sure you are using the latest AZ Controller, so in the lower right corner you see 0.5r9b412

AZ Controller does not trace changes of preset accurately, you can in general ignore "*" near its name. Current version of Cakewalk save preset when you close plug-in GUI. Previous versions of Cakewalk was saving on exit. So "*" was never about current preset, but named preset (they are saved separately).