Hello Alexey
1) ok disarm all works
2) ok
3) ok
4)
Well, that you better check in the editor. If I remember correctly, there is a "name" and there is the OSC command the control send.
well, I've tried again with different config : start from original osc phone 1.1, tried without project in sonar, with exact same name and /name in osc editor etc.. but still this bug who result by "/accxyz" recorded when assigning osc on the hardware page of AZ controller.
Just a precision : the only success time was after fresh install of last AZ version, with the add of a push UNDO button. I have tried after reinstalled last AZ version but no success with my osc adress, still got "/accxyz".
I proceed like that :
After created a push button with touchosc editor, I enter a name, and osc adress /name.
I transfer the file (sync) in the tablet.
In the osc phone file, I create in the option tab, from a new control from hardware control, with the /name and choose pad (sometimes nothing but it doesn't change anything in the result).
In the hardware tab, I find the /name hardware control, I attach it then ((None)) /test : appears in logical control.
I push the /name button ont tablet (I've tried before "attach" operation too)
I assign osc and..... "/accxyz" is the osc adress assigned.....
Edit : tried earlier versions of AZ with clean desinstall, with clean 1.0 and 1.1 spp, with auto osc for automatic address... Still got the f...... Bug.