Hi all,
Ok, it was very hot - but here is the next step forward with the BCR2000 preset.
Still some things to do, but many of the last ideas are implemented.
Additionally, some things are re-arranged, so please take a closer look at the included screenshot.
I tried to make the modes/functions understandable by different colors:
White labels ON the knobs are for 8Track-mode.
Colored labels below the knobs are for ProChannel-mode. Some have a second function with shift.
For all global buttons on the right: Labels in Blue are Shift-functions, and Green are Ctrl-functions.
Labels with a * mean that this state is shown by the LED.
Labels with two ** mean that this state is shown by blinking LED.
I hope you get it from the picture, except one knob (ACT), all should be labeled correctly.
Major improvements:
- "sticky mode" with timeout (2 sec) for Shift/Ctrl, so you can press buttons one after another.
- top row LED-rings can be toggled between VOL/VU
- Speed-Dial for almost all Sonar-Controls (+/-)
- Split & Cut Clips from BCR:
for now this is done by keyboard-simulation (until implemented in AZ), so may not always be reliable.
for me it´s working 100% reliable if i first: select the track, maximize it, and then click with mouse on any clip (this has to be done only ONCE for the track you work on).
Because the actions are split into 2 parts for button press/release, it´s also better not to release it too fast!
therfor these commands only work with the Ctrl-button held down (no sticky mode here).
the same also for: - Gain Commands +/- 1/3 dB
note: i removed some unwanted dB-presets in the Gain-dialog (0,5) so you will have todo either the same, or just edit the number key Up/downs in the function f_Gain.
And of course you can extend the concept to more gain-stages (Mode:Gain). - Tempo changing by Knob R8:
press Ctrl, then within the timeout (2 sec) touch the Knob (next to stop) and you are in Tempo-mode.
When finished with tempo-changes, press Stop to close the Tempo-Window.
- Jog/Scrub-Changes:
Default is now Jog (without Scrubbing), this is better for selection.
Scrub-Mode can be toggled On/Off with Ctrl+Jog - Escape-function:
switches the BCR to preset nr. 2, so the BCR can be used with other gear.
No need to send Prgm-Changes or the like.
some more additions, which i don´t remeber...
The attachement must be renamed to ZIP and consists of:
- Preset for BCR (SysEx) - this has not changed from Beta2, no need to load that again!
- the new Preset for AzCtrl BCR2000_beta3
- Higher Resolution Picture
Note: You need at least AZCtrl version 0.4r1b250 for this preset
First time users should read the threads to Beta1+2 for installing and additional infos.
Hope it works for you and as always, feedback is welcome.
martin (MarKo).