Author Topic: AZ Display: Logical On/Off for 'Rude mute/solo' monitoring [there is a solution]  (Read 5661 times)

Offline Hermu

  • Jr. Member
  • **
  • Posts: 53
monitoring values for 'Rude mute' and 'Rude solo' shows 0.0 or 1.0 instead On/Off similar 'Mute' or 'Solo'
« Last Edit: September 23, 2015, 05:33:38 PM by azslow3 »

Offline azslow3

  • Administrator
  • Hero Member
  • *****
  • Posts: 1679
Not sure I understand for what it is good, but implemented (in the test version for now).

Offline Hermu

  • Jr. Member
  • **
  • Posts: 53
I have attached AZ Display monitor for Mute and Rude mute, but i meant On/Off should be language specific.

it shows state of muted channels. if one or more channels are muted, also 'Rude mute' is on. with 'Rude mute' button it's possible to switch all muted channels off, or to switch all channels to mute.

Offline azslow3

  • Administrator
  • Hero Member
  • *****
  • Posts: 1679
Ok, you get it language specific now.

I know what they are, but "Yes/No", "Ein/Aus" or "Да/Нет", that is normally not the best representation way for these parameters. Even when I want them on Display, I prefer "Rude solo" if it is there and "" (Nothing!) if not.

You can put "Solo nicht vergessen!" or something else, but clearly visible. That is why I was never using direct text representation...

Offline Hermu

  • Jr. Member
  • **
  • Posts: 53
Thanks for your fast support, that's the best solution  :)