TouchDAW with AZ Controller (or "Mack.. Logic Control explained")

[azslow3]

Reference for the MC preset

Just short description what is what here.

Software State Sets

• Device - indicate either we have finished handshaking or not (yet)
• M1-M4, Edit, Numeric, Zoom - define that "modifiers" is active, M1-M4 are "Shift" like (active when the button is pressed), other are "Caps Lock" like (active till pressed again)
• Assign mode - Single/Multi, changed when you press the same assign button after that assign mode is activated
• Assign - change the mode
• LCDUpdate - enable  LCD Display output
• Meters - enable level meters
• Strip - use strip names or number on LCD display
• LCD - use parameter names or values on LCD display
• Navigation - how to interpret transport navigation keys
• CtrlGrp - which strip type we control
• JogParam - use Jogger for parameter navigation or for time line
• Jog - units for Jogging
• JogDir - supplementary state for jogging actions definitions
• Faders - enable motors
• TimeFormat - format of Time Display
• Flip - flip sliders/encoders
• FlipDisp - flip lower/upper LCD display lines
• EQMode - supplementary for EQ FG mode
• OffXYZ - X is Assignment, Y is CtrlGroup (Track/Bus), Z is Single/Multi Assignment mode. Define the first parameter to control
• OffACT - first controller ACT parameter offset
• PlugNY - Y is Track/Bus, FX plug-in number to control
• MasterFaderTouched - set when it is
• FTouchedI - set when the Fader I is touched
• The rest are temporarily "variables" for the logic

Hardware controls always have one Context and so one Logical Control. MC defines no hardware presets (unlike other, general oriented surfaces).

• There are many controls with the same names as corresponding Software Control States already named, I will not list them here
• Hello - react on "EHLO" message, means