Reference for the MC presetJust short description what is what here.
Software State Sets- Device - indicate either we have finished handshaking or not (yet)
- M1-M4, Edit, Numeric, Zoom - define that "modifiers" is active, M1-M4 are "Shift" like (active when the button is pressed), other are "Caps Lock" like (active till pressed again)
- Assign mode - Single/Multi, changed when you press the same assign button after that assign mode is activated
- Assign - change the mode
- LCDUpdate - enable LCD Display output
- Meters - enable level meters
- Strip - use strip names or number on LCD display
- LCD - use parameter names or values on LCD display
- Navigation - how to interpret transport navigation keys
- CtrlGrp - which strip type we control
- JogParam - use Jogger for parameter navigation or for time line
- Jog - units for Jogging
- JogDir - supplementary state for jogging actions definitions
- Faders - enable motors
- TimeFormat - format of Time Display
- Flip - flip sliders/encoders
- FlipDisp - flip lower/upper LCD display lines
- EQMode - supplementary for EQ FG mode
- OffXYZ - X is Assignment, Y is CtrlGroup (Track/Bus), Z is Single/Multi Assignment mode. Define the first parameter to control
- OffACT - first controller ACT parameter offset
- PlugNY - Y is Track/Bus, FX plug-in number to control
- MasterFaderTouched - set when it is
- FTouchedI - set when the Fader I is touched
- The rest are temporarily "variables" for the logic
Hardware controls always have one Context and so one
Logical Control. MC defines no hardware presets (unlike other, general oriented surfaces).
- There are many controls with the same names as corresponding Software Control States already named, I will not list them here
- Hello - react on "EHLO" message, means
